EAW KF730/SB730 Fly Bar

EAW KF730/SB730 Fly Bar

EAW KF730/SB730 Fly Bar Description:

EAW KF730/SB730 Fly Bar

Attachment to the Fly-Bar

The KF730 Fly-Bar design permits several methods of attachment.

1. Center Holes:

Use one of these holes for single point attachment, the particular hole being dictated by

the KF730 Wizard to result in the correct array tilt angle.

Use one hole in the rear and one in the front for bridling to a single point.

Use one hole in the rear and one in the front to attach two chain motors.

2. Corner Hoisting Points:

Use each side-to-side pair to bridle to single points for attaching two chain motors.

Rigging Methods

The two recommended rigging methods are:

1. Employ one chain motor, attached to particular Center Hole dictated by the KF730 Wizard

This will automatically result in the correct array tilt angle when all enclosures are flown.

One motor may be easier to deploy than two.

2. Employ two chain motors, one attached to the front of the Fly-Bar and the second to the rear.

The attachment can be to the Center Holes or the Corner Hoisting Points.

The array will be easier to assemble because it allows tilting the enclosures already

suspended to better match the angle of the next enclosure to be attached.

Once assembled, the overall tilt angle for the array can be easily adjusted.

Get your EAW EAW KF730/SB730 Fly Bar today!